Light Vehicle Premium
Seat Cover Fitting Instructions
Machine Washing Instructions
Wash on normal cycle with detergent.
Detergents high in bleach will accelerate
colour fading. High temperature water
and drying will promote shrinkage.
Step One
- Clean Seat and remove headrest. Position cover over the top of the backrest.
- Refit headrest. Adjust headrest to correct height now.
- Slip over cushion front. Do not cover up seat slide adjusting handle. Some covers have plastic hooks that hook around seat trim anchor points underneath the cushion front.
- Feed Straps through the gap between backrest and cushion.
Step Two
- Pull and wiggle straps from side to side, checking that the canvas flap attached to them is not scrunched up.
- Pull the straps tightly backwards (not upwards). This will settle the cover into place.
- Check that the seat cover is sitting over the seat properly.
Step Three
- Clip the buckles together (ensure that both teeth have correctly latched by gently attempting to pull the buckle apart).
- While tightening up the tensioning straps (pull tail back/side to side, then snig down) push the seat cover back into the seat at its backrest/cushion join.
© Copyright 2012
DingoSeatCovers Terms of Use