Light Vehicle Commercial
Seat Cover Fitting Instructions
Please Avoid Machine Washing
Step One
- Clean Seat and remove headrest. Position cover over the top of the backrest.
- Refit headrest. Adjust headrest to correct height now.
- Slip over cushion front. Do not cover up seat slide adjusting handle. Some covers have plastic hooks that hook around seat trim anchor points underneath the cushion front.
- Feed Straps through the gap between backrest and cushion.
Step Two
- Pull and wiggle straps from side to side, checking that the canvas flap attached to them is not scrunched up.
- Pull the straps tightly backwards (not upwards). This will settle the cover into place.
- Check that the seat cover is sitting over the seat properly.
Step Three
- Clip the buckles together (ensure that both teeth have correctly latched by gently attempting to pull the buckle apart).
- While tightening up the tensioning straps (pull tail back/side to side, then snig down) push the seat cover back into the seat at its backrest/cushion join.
© Copyright 2012
DingoSeatCovers Terms of Use